This problem has returned. I've done all of the same checks and still no solution. I am not getting power to the wire on the connector that should have power to trigger the relay. When I jump this wire to the battery, the relay clicks on and the car will start. Another issue worth mentioning is that...

It is reading 12.1V. Yesterday, when I mentioned it seemed a little low, it was 11.8V. I have pulled the ECU and reseated. That must have reset something because my OBD led light no longer dimly glows. I pulled the codes and reset. At this point, everything seems to be back to normal. I haven't driv...

It will not start again. I noticed that the 'UP Arrow" on the instrument cluster is flashing. Is this any indication of what may be wrong. The last time I started it, it died immediatly after about 10-15 seconds of run time. The arrow started flashing when it died.

Bobby

I used alligator clips to jumper from the connector to the relay. Although this didn't bypass the connector completely, I should have had a good connection to the terminals with the alligator clips. The erratic clicking was still there. I then connected the 2 coil terminals to the battery. The click...

I tested the relay as suggested and it appears to be good. I found the 2 legs that ohmed out about 80 and checked the relay with a power supply. The relay seemed to work as it should. The relay sounded solid as it opened and closed as I applied power and disconnected power. I left it connected for a...

Sorry for not posting the model. I have a 1995 850 Turbo.

I'll check into replacing the relay.

Thanks,
Bobby

i searched the forum for non starting issues. I am at a point I don't know what to do next. Here is what I have done so far. Fuel Pressure Check at fuel rail I put my hand on the fuel injector while trying to start the car. Could not feel them firing. I pulled the fuel rail/injectors and tried to st...

MIJ, You mention this hose in a previous post. The other end of the hose from "B" expands to a slightly larger hose. I expect the IAC to be there I had a 315 code and was looking things over. This hose is split, but I can't find it on the internet. Do you know the part number for this hose...

I have a 95 850 Turbo. The drive axle seal was leaking and I pulled it out. It had to be ordered so 2 weeks went by before I finally was able to put the new one in. This seal is different than any other seal that I have ever replaced. You can see a picture of the seal at this link. http://www2.maxim...

I have the ugrade kit but do not have any instructions on how to install it. I have read that there is a TSB that has instructions on the installations, but I have not been able to find a copy. Can someone give me the details I need to install this upgrade kit.

Thanks,
Bobby
[email protected]