Login Register

Search found 7 matches

by techedbob1
06 Oct 2012, 11:12
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: tire rotation
Replies: 1
Views: 531

tire rotation

What is the proper tire pattern for rotation front to back or back criss-cross to front?
by techedbob1
06 Oct 2012, 11:08
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: wheel alignment
Replies: 2
Views: 598

wheel alignment

I been told to align my 960 wagon that the struts must be removed in order to align it. Cost to remove 4 struts around 330 dollars.
Is this true or is someone trying to to make a buck?
by techedbob1
28 May 2012, 18:59
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: Replacing AC clutch on compressor
Replies: 5
Views: 4762

Re: Replacing AC clutch on compressor

If the cost of the clutch is just a few dollars less than a whole compressor what else would I need to replace?
by techedbob1
28 May 2012, 14:59
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: Replacing AC clutch on compressor
Replies: 5
Views: 4762

Re: Replacing AC clutch on compressor

The air conditioner was working then it wasn't. It had plenty of freon however it would not get cold. I took the car to my tech and he said that the clutch on the compressor was starting to freeze up. If I didn't fix it it would throw the belt and I would break down. Since it is my wife's car I did ...
by techedbob1
25 May 2012, 14:19
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: Replacing AC clutch on compressor
Replies: 5
Views: 4762

Replacing AC clutch on compressor

I have a general question. Is it hard to replace the ac clutch plate on the compressor.
1995 960 wagon.
by techedbob1
15 Apr 2012, 12:37
Forum: 240, 740, 760, 780, Bertone, 940, 960, V90, S90
Topic: 960 1995 Starter will not come out
Replies: 2
Views: 522

960 1995 Starter will not come out

I am trying to remove the starter from my 1995 960. I removed the two bolts, what a job. I can not seem to get the starter to move. I have tried hitting it with a hammer Lightly but to no avail.
I am looking for any suggestions.