"Brake assist service required" popped up again today. The replacement BPPS was working great and I got rid of the error message and cruise control was working great up until this. I hit a pot hole and it appeared shortly after this so maybe just jarred it loose, have to check in the morni...

Figured it out myself. No need to go under the car. I just used a butter knife with electrical tape and lightly pry the left edge (from angle shown in the picture) of the assembly and it easily pops off. Hope this helps somebody.

I have the error code "Bulb Failure Position Light" and I've replaced the license plate bulb and reverse bulb that were out. I notice one more bulb that is out and it is the orange reflector bulb on the outside front fender as show in the picture. How do I access this bulb to change it?? O...

Ok so I was able to stop by an awesome import junk yard near my town and I found a replacement BPPS for $25. It is the correct 3 wire version so I'm hoping it should work. This is from a 2005 S80 that has most likely sat for some time so not sure if it will still be in good working shape. Whats inte...

So my plug is different than others that are shown being repaired? I noticed the different location of the plug on my sensor but I figured it might still be the same connector. And opening it up to resolder the joints would fail most likely if I were able to get in without completely destroying the ...

I am interested in repairing the brake pedal position sensor for my 2004 S80 2.9L T6. I have the error message "Brake Assist Service Required" and "Engine Service Required" and I think this sensor may be the culprit. I was trying to follow the repair guide found here: http://www....