gavik wrote: ↑25 Dec 2025, 11:16

Dragoz001 wrote: ↑25 Dec 2025, 09:26OM?

OpenMoose

Yes!
I got the PIN in about 1 minute with it.
I needed it just because I want to remove the Infotainment Theft Protection with VDASH to make my MOST input module work (more than a few seconds...). I still have to do that.
Thanks to all for replying.

OM?

Thanks for your fast reply!
Oh. I thought it was... This ref is listed in the code.
Any other solution?

Hi all, Thanks for your great job here. I made the sketch with a Teensy 4.0 but I'm failing to connect to the HS CAN on my MY04 XC90. My CEM is a CEM-B, part number is 08688513 so it requires a K-Line activation. I use some transistors to send the K-Line keep alive message. I managed to see the LS C...

Hi, Here's a follow-up in case someone with the same issue gets here. Today I removed the angle gear and discovered that the seal sitting inside the sleeve behind the C clip (ref 8636195) was installed crooked. The lip was partly outside of the inner sleeve. It's not surprising that I got a big leak...

My gearbox is leaking oil. Its coming from between the tranny and the angle gear. The angle gear itself is almost new (PO had it replaced). I suspect the output drive shaft seal and would like to replace it. Does anyone have experience with this job? Is it possible to access it by "just" p...

Last update in case it may help someone in the future. The car now works perfectly! Smooth idle, good power and MPG increased drastically (from 18 l/100km to about 13). Basically I had 2 problems: - 1 recent was that the ECM failed (output for cyl #1) and had to be replaced - the 2nd was older (I sa...

For those interested I have some news about my problem.
The ECM works well actually.
I have found a second problem on the car!
There was a vacuum leak at the intake manifold gasket on cylinder 1 !

Hi, I finally can post some update on that problem! I ordered a used ECM fom eBay. The donor car was exactly the same as mine, released a few months later. I managed to find someone to clone my ECM into the one I bought. It took 2 weeks to send it and get it back... The engine started with the new E...

Thanks for the explanation.
Yes I checked the wire for short circuit.