I need access to the lower half of the fuse block in the engine compartment. The upper is comprised of a black main panel/body and a gray outer shell. I was able to lift the block partially but not with out consequence. There are two clips on the fender side, one clip towards the front side, one ...

The STC light does turn off with a 2 sec hold.

Not sure. Good to know about the 2 second thing though!

Installed! Brakes bled out at all four corners. No more seized wheel! ABS light out! The only issue that "turned up" is the STC light is on on the switch but won't deselect. We ran the car through its paces getting in the brakes good and hard and the system works as it should.

Just as a note, on ...

Found a used hydraulic block for $50 but it's one number off. Mine is 10.0208-0712.2 and theirs is 10.0208-0711.2. Keep in mind this is just the hydraulic block number. If needed I may be able to swap over the pump if the block is the same. It's hard to find info with these type Volvo numbers...

I do see a button inside for STC...

Yeah, the cores are gone. It seems that this was going on before the new caliper. I just did the usual suspect thing and changed out the caliper(cheap). I believe the caliper to be good, I do. I took the ABS coil pack off of the hydraulic block solenoids and that wheel does not release. All other ...

Clarification: the pads I took out of the old caliper looked new. I decided to use new pads because the "old" pads had a tab that was part of the back plate that was rolled over into the groove that the pad rides on on the brake bracket. These tabs were damaged/missing and the bracket had specific ...

Yeah, I didn't have to do that with this caliper, it came all the way in. That said the pads look almost brand new so maybe junior replaced the pads this way. I didn't get to pulling the ABS unit today due to too much running around and then eventual laziness (it was dark after all). Tomorrow should ...

Sorry guys, thought the car year was listed...newbie. It's a 2003 S60 base model. The caliper/bracket/pads are brand new and slide easily. The wheel is locked up currently. pressure can be released at the bleeder valve at which point the wheel turns freely until the pedal is depressed again. The ...