Search found 238 matches
- 05 Mar 2020, 12:28
- Forum: S60 2011+ V60 2015+ XC60 2010-18
- Topic: 2010 xc60 piercing sound
- Replies: 3
- Views: 1121
Re: 2010 xc60 piercing sound
So, I am thinking that I can put a zip tie on the dip stick to hold keep it from sealing to vent the vacuum, and not damage the engine so I can get it home?
- 05 Mar 2020, 09:19
- Forum: S60 2011+ V60 2015+ XC60 2010-18
- Topic: 2010 xc60 piercing sound
- Replies: 3
- Views: 1121
Re: 2010 xc60 piercing sound
Yes, that is the problem. Thank you very much.
- 04 Mar 2020, 21:06
- Forum: S60 2011+ V60 2015+ XC60 2010-18
- Topic: 2010 xc60 piercing sound
- Replies: 3
- Views: 1121
2010 xc60 piercing sound
Anyone heard this before? Another symptom that is new is if you are sitting in park and blip the throttle it will hold at 2000rpm until you blip it again or put it in gear. That happening is not consistent though. This morning it was 50 degrees and the squeal is not as loud as the video. Maybe a ...
- 03 Mar 2020, 07:04
- Forum: C30, C70 2006+, S40 & V50 2004 ½ +
- Topic: Looking for C30
- Replies: 1
- Views: 613
Looking for C30
Hello, I am looking for a C30, automatic, blue. Looking in the neighborhood of $5000, so an older one that isn't in pristine shape. I am located in Knoxville, Tennessee. I looked at the classified forum but the search didn't turn up anything. Thanks, Alan
- 08 Jan 2020, 13:17
- Forum: S60 2011+ V60 2015+ XC60 2010-18
- Topic: XC60 Headlight Washers
- Replies: 2
- Views: 1262
XC60 Headlight Washers
Hello. We purchased an XC60 that has headlight washers. Is pulling the fuse the best way to disable them? Here is the south we don't have a use for them, and they use a lot of fluid. Thanks.
- 27 Dec 2019, 11:41
- Forum: Volvo Classifieds
- Topic: 2010 XC60 door and fender
- Replies: 0
- Views: 397
2010 XC60 door and fender
Anyone have a door with power folding mirror and drivers fender from a silver 2010 XC60? Thanks.
- 24 Jul 2019, 08:38
- Forum: XC90 1st gen 2003-2014
- Topic: 2004 XC90 Brake Switch
- Replies: 1
- Views: 1100
2004 XC90 Brake Switch
Hello. My XC90 has the "Brake System Failure Stop Safely" warning on the dash. My code reader has a code for Brake Switch Malfunction. I replaced the brake switch (a difficult job given its location on the brake pedal arm). Has anyone seen anything describing how to properly set the adjustment for ...
- 13 Mar 2019, 08:53
- Forum: XC90 1st gen 2003-2014
- Topic: 2008 XC90 V8 cylinders
- Replies: 1
- Views: 1459
2008 XC90 V8 cylinders
Hello, Does anyone have a diagram with the cylinder numbers listed for the V8? Or, if anyone can explain it verbally as if you were standing in front of the vehicle looking at the engine. Thanks, Alan
- 09 Jul 2018, 11:39
- Forum: XC90 1st gen 2003-2014
- Topic: 2004 XC90 trailer wiring harness
- Replies: 4
- Views: 2728
2004 XC90 trailer wiring harness
Has anyone installed a factory trailer wiring harness on their XC90? There are a few of the after market varieties out there that require splicing, etc. But a factory harness looks like it has just a plug that goes on, and done. I have found factory sets for a 2004 V70 but not my XC90 yet. Thanks.
- 23 Jan 2018, 12:46
- Forum: S60 2011+ V60 2015+ XC60 2010-18
- Topic: 2010 XC60 rear brake
- Replies: 1
- Views: 1684
2010 XC60 rear brake
I took my XC60 to my normal non-volvo mechanic to replace the rear brake pads. I was told that you have to use a special scan tool to tell the electronic parking brake to release. They tried with a couple of different scan tools and had no luck. Does this sound right? Is there any way someone other ...






