How to remove a certain light bulb...

Post by **E170_Driver** » 17 Feb 2010, 16:37

The light behind the driver's side temperature dial went out. How do I remove this unit from the console/dashboard in order to get to the bulb? Anything to worry about while going in?

Thanks much

Jan

Joe Hurless · Post by **Joe Hurless** » 17 Feb 2010, 17:12

The key to this is that little strip of moulding at the bottom with the little rubber tab on it. Use a pocket screwdriver to get into the sides and pry that little panel off of there. underneath will be a few screws to remove. Just go from there and you'll be all set.

There's not a lot to worry about here. Most parts clip in... removing them may make you feel like your going to break them. Just be firm and you'll be fine.