Login Register

S60 check engine light came on

Help, Advice, Owners' Discussion and DIY Tutorials on Volvo's stylish, distinctive P2 platform cars sold as model years 2001-2007 (North American market year designations).

2001 - 2007 V70
2001 - 2004 V70 XC (Cross Country)
2004 - 2007 XC70 (Cross Country)
2001 - 2009 S60
2003 - 2007 S60 R
2004 - 2007 V70 R

Post Reply
iwritecopy
Posts: 26
Joined: 25 February 2010
Year and Model: S60 2002
Location: Minnesota

S60 check engine light came on

Post by iwritecopy »

2002 S60 118k

For the past several months, I would get a "fuel filler cap loose" message. Replaced the fuel cap gasket last summer...to this day, the message still comes on periodically. Today, the check engine light came on. Stopped by an Autozone store and had the fault code read. Fault code says EVAP "faulty vent solenoid". I go on volvo parts sites and that part name is not found. No repairs done in the last 8-9 months.
Where is this solenoid, and is it easy to replace? In the Haynes manual difficulty scale (1-5 wrenches), I am able to do up to 3. Thanks for your time & help!

Dave

OEMVolvoParts
Posts: 266
Joined: 31 August 2009
Year and Model: ALL
Location: CA

Post by OEMVolvoParts »

There is a purge valve and a shut-off valve that could be causing that code. Depends on the vin number or I would give you part numbers. Email us the vin and I can get part numbers for you.

iwritecopy
Posts: 26
Joined: 25 February 2010
Year and Model: S60 2002
Location: Minnesota

Post by iwritecopy »

Thanks for your quick reply. My VIN is

YV1RS61R922172322

thanks!! Dave

iwritecopy
Posts: 26
Joined: 25 February 2010
Year and Model: S60 2002
Location: Minnesota

Post by iwritecopy »

Hi,

It turned out to be the purge valve - thank you! this is fixed.

Georgeandkira
Posts: 882
Joined: 7 April 2009
Year and Model: '07 V70 + '15 XC70
Location: Hudson & Champlain Valleys, USA
Has thanked: 64 times
Been thanked: 69 times

Post by Georgeandkira »

Hello, Where was this purge valve located? Did you get a part number? And, most importantly, how much did it cost? Thanks, Kira

iwritecopy
Posts: 26
Joined: 25 February 2010
Year and Model: S60 2002
Location: Minnesota

Post by iwritecopy »

Hi,

my mechanic is replacing it tomorrow for just under $300 parts & labor. You can get that cannister purge valve for around $170-200, but with what you have to remove to get to it, it was worth it for me to have my mechanic do it (my garage isn't heated, and it's still in the 30s here...

Post Reply
  • Similar Topics
    Replies
    Views
    Last post