I just picked up a set of power seats for a 2001 XC-70 that I'd like to put in my 64 Chevelle Wagon.. can anyone help me figure out how to wire them up to use the motors and heater.. The car was rear ended and totaled out... I do have a wiring diagram showing the red and black as power in but I can get any motor to run..I see there is a stop logic relay somewhere, is this possibly what's keep them from running...
Any help I can get would be highly appreciated...
2001 XC70 seats in '64 Chevy Chevelle?
-
olddog1946
- Posts: 1
- Joined: 13 August 2010
- Year and Model: 2001
- Location: Washinton
-
JRL
- Posts: 9350
- Joined: 22 November 2005
- Year and Model: Several
- Location: 19333
- Been thanked: 16 times
The seats power, memory and general electrical runs through the CAN-BUS system which is way above my pay grade to figure out.
They have switch modules that require software, etc
You may want to try to get 98-00 seats, more comfy (IMO) and easier to work with.
They have switch modules that require software, etc
You may want to try to get 98-00 seats, more comfy (IMO) and easier to work with.
Mod note. Jim passed away in early 2022, his contributions to this forum are immortal, and he is missed. RIP
2000 V70R Black, 144,000 miles Wife's R.
2007 V70 2.5T White/Oak 111,000 MILES. Polestar tune, IPD bars, rear spoiler, dark grey Thors, DWS 06, HU850, sub.
2000 V70R Black, 144,000 miles Wife's R.
2007 V70 2.5T White/Oak 111,000 MILES. Polestar tune, IPD bars, rear spoiler, dark grey Thors, DWS 06, HU850, sub.
As long as the motors are all there, you should be able to wire them yourself utilizing relays and a fabricated switchpack. You may be able to use the factory pack if you are technically inclined. I work on Jaguars for a living and I'm certain I could do this with a Jag seat....it would just take time and patience.
-
- Similar Topics
- Replies
- Views
- Last post