fan trouble
-
Ozark Lee
- MVS Moderator
- Posts: 14798
- Joined: 07 Sep 2006, 08:24
- Year and Model: Many Volvos
- Location: USA Midwest
- Has thanked: 4 times
- Been thanked: 76 times
Which fan? The cabin HVAC blower or the engine cooling fan?
...Lee
...Lee
'94 850 N/A 5 speed
'96 Platinum Edition Turbo
Previous:
1999 V70XC - Nautic Blue - Totaled while parked.
1999 V70XC - RIP - Wrecked Parts Car.
1998 S70 T5
1996 850 N/A
1989 740 GLT
1986 740 GLT
1972 142 Grand Luxe
'96 Platinum Edition Turbo
Previous:
1999 V70XC - Nautic Blue - Totaled while parked.
1999 V70XC - RIP - Wrecked Parts Car.
1998 S70 T5
1996 850 N/A
1989 740 GLT
1986 740 GLT
1972 142 Grand Luxe
-
jimmy57
- Posts: 6696
- Joined: 12 Nov 2010, 09:25
- Year and Model: 2004 V70R GT, et al
- Location: Ponder Texas
- Has thanked: 5 times
- Been thanked: 322 times
You may have the low speed not working. When that happens the a/c pressure goes high enough to trigger hi speed and then hi speed runs briefly and pressure drops and it reverts to low speed but low speed isn't blowing so the cycle repeats.
The fan relay is just under RH (passenger side) end of the fan shroud top plate. It slips out to the rear. The low speed trigger is yellow white and the hi speed is solid yellow. Make sure the Y-W hasn't slipped out of the grey connector. The plastic around those bullet connectors turns to goo with age.
If that is all good then disconnect the large gauge wire 2 wire connector. Use a jumper wire between battery and touch the connectors one at a time. You should be able to get fan to run at low and hi speeds. If this is all good then get a fan relay.
The fan relay is just under RH (passenger side) end of the fan shroud top plate. It slips out to the rear. The low speed trigger is yellow white and the hi speed is solid yellow. Make sure the Y-W hasn't slipped out of the grey connector. The plastic around those bullet connectors turns to goo with age.
If that is all good then disconnect the large gauge wire 2 wire connector. Use a jumper wire between battery and touch the connectors one at a time. You should be able to get fan to run at low and hi speeds. If this is all good then get a fan relay.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 387 Views
-
Last post by Dottelito
-
- 1 Replies
- 1180 Views
-
Last post by neworleans
-
- 8 Replies
- 4073 Views
-
Last post by moacyr
-
- 15 Replies
- 2893 Views
-
Last post by Matty Moo
-
- 18 Replies
- 3381 Views
-
Last post by francisp






