Testing the MAF
-
2forty
- Posts: 114
- Joined: 21 December 2011
- Year and Model: 850 1996
- Location: Albuquerque NM
- Been thanked: 2 times
Testing the MAF
How do you test a MAF sensor on a 87 240? While driving the car it begins to run rough then dies at a stop.. it will not restart. I disconnect the MAF then reconnect it. It starts but runs very rough.. make it to a parking lot and call a tow truck to get me home.. I take off the MAF to spray it off with MAF cleaner but it is clean so I install it and drive it around the block a couple of times... it idles a little rough... I believe it is the MAF but want to make sure. I replaced the MAF in 2001.
check this video:How do you test a MAF sensor
http://www.ehow.com/video_5225929_mass- ... r-bad.html
Get yourself a good DVM or an oscilloscope.
good luck.
jmmxc
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 518 Views
-
Last post by postoak
-
- 10 Replies
- 1597 Views
-
Last post by albertoVO5






