I have been dealing with this problem for quite some time now. Basically when I start the car the idle fluctuates between 700-1200 rpms, and throttles itself back and forth. While in Park or Neutral it will continue to ide back and forth, but once I have put it in gear (reverse or drive), the rpms will decrease (and die) if gas is not applied. Here is a list of repairs I have done so far:
Distributor cap
Roto Button
Spark Plugs
Ignition Coil
MAF sensor
Throttle Positioning Sensor
Three vacuum hoses labed yellow, red and blue which are attached to the air fliter container
My check engine light is now off and the idling problem has improved, but there is still the constant fluctuation of rpm and occasional dying. Any suggestions or solutions? I have read these might be possible solutions: Idle air control valve, Fuel Regulator Sensor, or possibily a cracked or broken intercooler line from under the car.
Any ideas or suggestions would be greatly appreciated
Thanks Guys
96 850 Turbo- Still having Idle problems, suggestions?
- matthew1
- Site Admin
- Posts: 14479
- Joined: 14 September 2002
- Year and Model: 850 T5, 1997
- Location: Denver, Colorado, US
- Has thanked: 2655 times
- Been thanked: 1248 times
- Contact:
No codes?
Help keep MVS on the web -> click sponsors' links here on MVS when you buy from them.
Also -> Amazon link. Click that when you go to buy something on Amazon and MVS gets a cut!
1998 V70, no dash lights on
1997 850 T5 [gone] w/ MSD ignition coil, Hallman manual boost controller, injectors, R bumper, OMP strut brace
2004 V70 R [gone]
How to Thank someone for their post

Also -> Amazon link. Click that when you go to buy something on Amazon and MVS gets a cut!
1998 V70, no dash lights on
1997 850 T5 [gone] w/ MSD ignition coil, Hallman manual boost controller, injectors, R bumper, OMP strut brace
2004 V70 R [gone]
How to Thank someone for their post

-
jblackburn
- MVS Moderator
- Posts: 14043
- Joined: 8 June 2008
- Year and Model: 1998 S70 T5
- Location: Alexandria, VA
- Has thanked: 9 times
- Been thanked: 19 times
What codes were on before with the check engine light?
I would definitely clean the idle control valve and throttle body if there are no longer any codes.
I would definitely clean the idle control valve and throttle body if there are no longer any codes.
'98 S70 T5
2016 Chevy Cruze Premier
A learning experience is one of those things that says, "You know that thing you just did? Don't do that."
mercuic: Long live the tractor motor!
2016 Chevy Cruze Premier
A learning experience is one of those things that says, "You know that thing you just did? Don't do that."
mercuic: Long live the tractor motor!
So check engine light did come on, which showed codes p1310 and p0300 and I'm fairly certain those are for misfiring for the cylinders. I cleared them this am and they have yet to show back up. I did not replace the spark plug ignition wires, I ordered them and should receive them tomorrow or thursday at the latest. I believe this might be a solution to the idle which now is less prevalent but still noticeable at times. Thoughts?
-
JimBee
- Posts: 1915
- Joined: 9 December 2008
- Year and Model: 93 and 2 96 850's
- Location: Minneapolis
- Has thanked: 25 times
- Been thanked: 42 times
Question: at highway speeds, does it straighten out and run normally?
If so, I would think this might eliminate plug wires, since if they were shorting, they'd most likely do so at any rpm, under load or not. What do you think?
If so, I would think this might eliminate plug wires, since if they were shorting, they'd most likely do so at any rpm, under load or not. What do you think?
The idling is drastically improved from where it was, but it is still there, while yes the car runs fine at highway speeds, you still feel the misfire in while driving every so often, which is to say you feel it miss and then catch it self even if it is ever so slight, i think the wires may still work since it is the only thing I didn't replace in the sequence from plugs to coil. The only other thing is to clean the idle air control valve which may be the cause as well
-
JimBee
- Posts: 1915
- Joined: 9 December 2008
- Year and Model: 93 and 2 96 850's
- Location: Minneapolis
- Has thanked: 25 times
- Been thanked: 42 times
I asked about the highway performance b/c I picked up a '96 turbo last August that has a similar condition—only wildly erratic when idling cold. I drove it on a 70 mile highway trip and warmed up, it seemed pretty normal. It's been sitting since, but I'll be back playing with it soon. I'm wondering if it's a vacuum leak. I plan to replace the elbows on the vac lines and the throttle body gasket. I've done most of things you listed and the problem persists. Keeping it running while it was surging and dying must have flooded the cylinders b/c my cat go really hot. So I also plan to clean the injectors, replace their seals and maybe have them checked if I can find a shop that does that.
Someone posted a couple of months ago about pouring paint thinner in the gas tank and letting it run through the engine to clean things up. There's a UTube video posted by a mechanic who says he's been doing it for years. I'm going to post a question to the group about it.
Someone posted a couple of months ago about pouring paint thinner in the gas tank and letting it run through the engine to clean things up. There's a UTube video posted by a mechanic who says he's been doing it for years. I'm going to post a question to the group about it.
-
Sean-E-Boy
- Posts: 14
- Joined: 29 June 2010
- Year and Model: 1995 850 2.3T Wagon
- Location: California, USA
1. Check the vacuum line connection on the left of the intake manifold.
2. Check/test the EVAP system.
On my 850, disconnected vacuum line at left side of the intake manifold caused rough idle and rough low end acceleration as well as the misfire codes.
Also, broken lines on both sides of the fuel tank roll-over valve resulted in spontaneous stalling (sometimes 2 or 3 times a day, other times a week or more between stalls). What's worse, A-2 never logged a trouble code for the EVAP, only discovered it after failing that portion of the smog test.
2. Check/test the EVAP system.
On my 850, disconnected vacuum line at left side of the intake manifold caused rough idle and rough low end acceleration as well as the misfire codes.
Also, broken lines on both sides of the fuel tank roll-over valve resulted in spontaneous stalling (sometimes 2 or 3 times a day, other times a week or more between stalls). What's worse, A-2 never logged a trouble code for the EVAP, only discovered it after failing that portion of the smog test.
-
- Similar Topics
- Replies
- Views
- Last post






