1994 3ltr 960 24v Lambda sensor replaced

father ted · Post by **father ted** » 16 Oct 2012, 11:32

As my recent cries for help will show my Lambda sensor light came on and so i decided to renew the sensor. After purchasing the correct part from a reputable dealer (£65) and fitting it myself according to the manufactures instructions found that the Lambda warning light was still illuminated. Have i missed something, should the warning lamp fix itself or do i have to manually remove any fault codes that may be still there. Any help will much appreciated.

Post by **boosted5cyl** » 16 Oct 2012, 12:58

Post by **boosted5cyl** » 16 Oct 2012, 13:00

Sorry saw your username and couldn't resist. What was the exact code you were getting beforehand?

father ted · Post by **father ted** » 16 Oct 2012, 13:34

: 423972_10150723261519245_647604244_11471253_1933846299_n.jpg (29.64 KiB) Viewed 611 times

Thats ok my friend, just happy Ted is still recognised. I have to admit i know very little about fault codes and even less about how to read them. I just assumed by replacing the sensor with a new one it may clear the warning light. Apparently not. One thing i did not do was to remove the battery terminal before installing and maybe this may have cleared the fault. Perhaps i need to read up on this aspect of repair before i do some real damage! Thanks for your concern.

Post by **billofdurham** » 16 Oct 2012, 15:20

You do have to erase the code. This is done using the On-Board Diagnostic (OBD) unit in the engine compartment. Instructions for its use are pinned at the top of this forum.

Bill.