Broken OBD1 probe wire

Post by **polskamafia mjl** » 16 Jul 2013, 14:37

The probe wire for my OBD1 port is servered. Anybody know where I can get another one?

: Severed OBD1 Probe Wire

Post by **jimmy57** » 16 Jul 2013, 14:59

Look around under the hood for an unused connector with those bullet terminal wires in it. Clip the wires and then remove the grey connector body leaving you with two wires with the bullet style terminal on end like in your picture. If you can't find some unused connector to harvest wires from then you can go scrapyard hunting for the same. They are used on 240/740/940/960/760/780 and to a lesser extent on 850's.
Find the tab to push over and it will let you lift the obd plug off the support. Then grasp the OBD by the tabs on either side and pull it out of the harness. Now you use a solder gun and remove the broken lead and replace it with one of your harvested leads.

Post by **polskamafia mjl** » 16 Jul 2013, 21:50

I don't have any pick and pulls near me that I know of, otherwise I would grab one off a junked 850. No way to get one from the dealer?

Post by **Ozark Lee** » 17 Jul 2013, 10:06

I am going to a Pick N Pull tomorrow and I believe there is a '95 there with the DTC box intact. I'll snag it for you if you would like. My guess is that they will charge me around $5.00 for it - on stuff that isn't listed on the price list they kinda make it up as they go.

Let me know.

...Lee

Post by **rspi** » 17 Jul 2013, 14:54

Same here. The pick-n-pull is full of them. The entire box is connected with one plug connector.

Post by **jimmy57** » 17 Jul 2013, 15:59

PM me. I have one I just walked out and pulled off a 95 960 that is soon to be sold by the pound. The part is in exceptional shape with cover tether still intact. Free, you pay shipping.

Post by **polskamafia mjl** » 18 Jul 2013, 01:35

Thanks for the offers guys. I already PMed Lee.