Login Register

Caliper Stuck, 99, S70

Help, Advice and DIY Tutorials on Volvo's P80 platform cars -- Volvo's 1990s "bread and butter" cars -- powered by the ubiquitous and durable Volvo inline 5-cylinder engine.

1992 - 1997 850, including 850 R, 850 T-5R, 850 T-5, 850 GLT
1997 - 2000 S70, S70 AWD
1997 - 2000 V70, V70 AWD
1997 - 2000 V70-XC
1997 - 2004 C70

Post Reply
kokee
Posts: 2
Joined: 8 June 2007
Year and Model:
Location: Bel Air, MD

Caliper Stuck, 99, S70

Post by kokee »

I replaced brakes w/aftermarket brake pads, no issues for about a month afterwards. Suddenly, the driver-side caliper began locking - the problem is intermittent and I can hear a slightly friction between the pad and the rotor when the caliper is not locked. Was it coincidence that these symptoms started after replacing the pads? The caliper is not leaking, the car has 55K miles
Last edited by kokee on 09 Jun 2007, 09:30, edited 1 time in total.

turbotim2
Posts: 708
Joined: 4 February 2005
Year and Model:
Location: Maine

Post by turbotim2 »

I had this problem too, go ahead and change them out with some from FCP Groton, they come fully loaded with new pads for around $60/ea. It is an easy job, and maybe check your front hoses at the same time if you haven't in awhile. That caliper will wear those pads right out, could warp your rotor and will make your fuel mileage go down significantly.
2004 XC70

2005 S60 2.5T AWD (gone)

1996 850 GLT Wagon in Blue (gone)

1996 850 GLT Wagon in Green (gone)

Ozark Lee
MVS Moderator
Posts: 14798
Joined: 7 September 2006
Year and Model: Many Volvos
Location: USA Midwest
Has thanked: 4 times
Been thanked: 75 times

Post by Ozark Lee »

When you changed the pads did you lubricate the pins?

When I change pads I run a very thin coat of grease on the pins and also on the mating surface between the caliper and the mount.

...Lee
'94 850 N/A 5 speed
'96 Platinum Edition Turbo
Previous:
1999 V70XC - Nautic Blue - Totaled while parked.
1999 V70XC - RIP - Wrecked Parts Car.
1998 S70 T5
1996 850 N/A
1989 740 GLT
1986 740 GLT
1972 142 Grand Luxe

TheDrivenMan
Posts: 11
Joined: 4 May 2007
Year and Model:
Location: TN

Post by TheDrivenMan »

I wouldn't expect this on a newer car, but I have had a couple of 20+ year old cars where a brake hose deteriorates on the inside and acted as a oneway valve.

The brake fluid gets pushed through the hose by the master cylinder, but the hose collaspes when their is no pressure and traps fluid at the caliper causing the brake to hold.

R
Robert

The Driven Man

New Owner 1995 850 Turbo Wagon

www.TheDrivenMan.com

Post Reply
  • Similar Topics
    Replies
    Views
    Last post