Headlight wiper motor wiring

Post by **mecheng** » 30 May 2018, 08:06

Does anybody know where Headlight wiper motor wiring harness is, I can't seem to find it.

I want to keep the OEM look and leave the blades but disable just the passenger wiper motor which has a mind of its own where it finds its park position.

Thanks

Post by **scot850** » 30 May 2018, 09:00

The wires for the motors has a join that is clipped just above the headlights. It is usually a brown connector with a push wire to disconnect.

: Engine bay

In the lower part of the picture you can see a brown connector not connector to anything. That is the headlight wiper motor connector. Just below it to the right you can just see the edge of the connector it should clip into under the edge of the slam panel in the same color.

Neil.

Post by **mecheng** » 30 May 2018, 09:23

For posterity and clarity, is the circle the correct connector?

Thank you Scot!

Post by **scot850** » 30 May 2018, 10:27

That is one half. If you look slightly lower to the edge of the slam panel and just to the right of the with cable label you can see the other part where it plugs into. It is the same color. The connector you have circled it the cable end leading to the motor itself.

Neil.

Post by **mecheng** » 30 May 2018, 10:30

Thanks Neil, not Scot, my mistake. Still rocking the amp you sold me!

Post by **oragex** » 30 May 2018, 10:30

You may also need to undo the water hose to the headlight wiper, it looses quite a good amount when spraying the windshield.

Not sure where it's connected to the reservoir.

Post by **scot850** » 30 May 2018, 10:43

You can remove it from the wiper arm and just tie a knot in the end of the pipe and tuck it behind the panel.

Glad the amp is working well!

Neil.

Post by **mecheng** » 30 May 2018, 12:26

scot850 wrote: 30 May 2018, 10:43 You can remove it from the wiper arm and just tie a knot in the end of the pipe and tuck it behind the panel.

Glad the amp is working well!

Neil.

Ya, I had the arm removed, but didn't have the motor removed so I got tired of that look and wasn't ready to remove it completely for any future buyer. I like the look of the wipers, and maybe if I keep the liquid connecting it should clean the headlight from the wind pressure. Tieing a knot is not a bad idea, I had some electrical tape.

Thanks all