Turbo flange and down pipe?

Gmstewart22 · Post by **Gmstewart22** » 02 Oct 2018, 19:55

evening all,My question is in regards to the down pipe on my 2000 v70 GLT. is this exhaust flange and size the same on the HPT cars? curious if a down pipe from a hpt will work on lpt. thanks

Post by **abscate** » 02 Oct 2018, 20:22

There are flat and angled flanges but I don’t know what has what.

Gmstewart22 · Post by **Gmstewart22** » 02 Oct 2018, 20:52

Are the sizes and bolt patterns the same on hpt and lpt's? Providing they are both strait flange?

Gmstewart22 · Post by **Gmstewart22** » 02 Oct 2018, 21:50

correction, my car has the angle flange turbo, are there any t5 that have the angle flange or was it just the lpt that were angle flanges. I just confirmed via.. removing the turbo shroud, deffinently an angle flange

Post by **abscate** » 03 Oct 2018, 03:01

My 99 T5 is angle flange

Volvo parts Lisle might help get this straight

Gmstewart22 · Post by **Gmstewart22** » 03 Oct 2018, 09:20

That would be helpful, I am finding countless Dow pipes for angle flange T-5 turbos but not much for my angle flange 3g LPT... perhaps the flange size is the same and downpipe are universal? However I remain sceptical until some Guru on here sets me straight!

Post by **Ozark Lee** » 03 Oct 2018, 22:23

I have a spare pipe but it is an angled flange. That pipe has a nasty habit of breaking right at the flange which is why I snagged a spare from the pick-n-pull.

Are there any measurements I can make on it that will help?

...Lee

Gmstewart22 · Post by **Gmstewart22** » 03 Oct 2018, 22:31

Ozark Lee wrote: ↑03 Oct 2018, 22:23 I have a spare pipe but it is an angled flange. That pipe has a nasty habit of breaking right at the flange which is why I snagged a spare from the pick-n-pull.

Are there any measurements I can make on it that will help?

...Lee

can you upload of the flange where it adapts to the turbo? also flange dimensions across the face?

Gmstewart22 · Post by **Gmstewart22** » 03 Oct 2018, 22:33

does anybody know if ipd will sell just the down pipe with the cat?

Post by **erikv11** » 04 Oct 2018, 08:03

Flanges are all the same diameter and bolt pattern at the exhaust manifold, the only difference is angled, straight or conical on the downpipe side. Conical is smaller diameter on the downpipe, too. They are all interchangeable otherwise.

Conical outlet flange: All 94-95 850 turbos

Straight outlet flange: All 96-97 850 turbos, All 98 x70 turbos

Angled outlet flange: 99+

some pics:

: turbo outlet flanges; turbo outlet flanges angled, straight, conical.jpg (53.83 KiB) Viewed 4908 times

: turbo outlet flange diameters; 1E61A409-E1E4-43FE-B90E-3F51964D3F9B-1730-00000134928A8B29.jpg (88.76 KiB) Viewed 4908 times