I'm looking for some advice on doing the engine harness on my 87 240 DL; I am sure I need to remove the intake manifold to get access to some sensors and connections under it, unless I'm missing something. Is it as easy as just unbolting the manifold, and sliding it up out of the way, or will I need to remove the fuel rail, Throttle body, and cables before moving the manifold?
Appreciate the help!
J
Replacing Engine Harness '87 240 (b230f)
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 799 Views
-
Last post by Flyingfish
-
- 14 Replies
- 4643 Views
-
Last post by CIK7
-
- 2 Replies
- 128 Views
-
Last post by BigLib
-
- 13 Replies
- 4434 Views
-
Last post by sergitin32
-
- 7 Replies
- 2607 Views
-
Last post by lummert