Can a 5 bolt p80 REAR hub fit on the 93 850 4 bolt axle

Post by **abscate** » 26 Oct 2019, 09:51

You can just JB Weld the wheel to the hub....or zip tie the four holes to the five..

Post by **misha** » 26 Oct 2019, 09:54

Did you also replaced air valves on the rims?
They could leak air.

Post by **JimBee** » 26 Oct 2019, 20:21

abscate wrote: 26 Oct 2019, 09:51 You can just JB Weld the wheel to the hub....or zip tie the four holes to the five..

abscate's creative imagination knows no limits—living in that neck of the woods, there's probably an Edisonian gene or two randomly distributed in the NY pool

Misha: I think the tech changes the stem when he grinds the rim, I'm sure he has in the past on other rims, maybe that one, too. They test for leaks using a spray solution of water with a dash of soap, so when it goes out the door, presumably it's leak-free. There should be a better goo that can fill even the minutest gaps.