What did you do to your Volvo today? Topic is solved

Post by **abscate** » 17 Jun 2020, 04:30

I’ve got ahold lower torque rod that I’ve been looking at in the garage too long, calling on me to make a bushingfroa hockey puck.

I’ve found you can get ALL the toothpaste out with a press.

Post by **abscate** » 17 Jun 2020, 05:03

Anyone in p80 land have one of these?

Volvo 940 2.3l Fuel Injected 1992, 1993, 1994, 1995
Volvo 940 2.3l Fuel Injected Turbo 1992, 1993, 1994, 1995
Volvo 940 SE 2.3l Fuel Injected Turbo 1992
Volvo 960 3.0l 6 cylinder Fuel Injected 1992, 1993, 1994, 1995, 1996, 1997
Volvo S90 3.0l 6 cylinder Fuel Injected 1997, 1998
Volvo V90 3.0l 6 cylinder Fuel Injected 1997, 1998

Need a picture with scale of the ac line hold down clamp

Thread here in the other forum

viewtopic.php?f=2&t=94273

Post by **kallekula** » 19 Jun 2020, 00:39

I replaced motor mounts on my bimmer

Post by **bmdubya1198** » 19 Jun 2020, 09:09

Wow, those are bad! This was the mount in my E39 after it was rear ended. Only damage the car sustained! Well, aside from the broken pedestal, but that was all an easy replacement.

Post by **smacknab** » 19 Jun 2020, 12:29

Replaced a torn vac tube from my carbon canister, hoping it solves my evap leak code.

dnd2526 · Post by **dnd2526** » 19 Jun 2020, 13:08

I told it how frustrated I am with my Saab. I also tried to fix some aging wiring issues while troubleshooting the radiator fan.

Post by **smacknab** » 19 Jun 2020, 15:35

I just seafoam's my 99 na per Mathews instructions and now I'm getting a p0327 code, which other posts here indicate to be a knock sensor wiring code. I reset the code and will see if it comes back on, but has anyone else had similar experiences?

Post by **kallekula** » 19 Jun 2020, 17:19

bmdubya1198 wrote: ↑19 Jun 2020, 09:09 Wow, those are bad! This was the mount in my E39 after it was rear ended. Only damage the car sustained! Well, aside from the broken pedestal, but that was all an easy replacement.

Huh, weird. Lucky they're so easy to replace.

Volvebaker · Post by **Volvebaker** » 19 Jun 2020, 19:00

Threw some new Konigs on her

Post by **abscate** » 20 Jun 2020, 04:28

smacknab wrote: ↑19 Jun 2020, 15:35 I just seafoam's my 99 na per Mathews instructions and now I'm getting a p0327 code, which other posts here indicate to be a knock sensor wiring code. I reset the code and will see if it comes back on, but has anyone else had similar experiences?

Pull the connector and clean it out well iff the code comes back. I bet it doesn’t.

What did you do to your Volvo today? Topic is solved

Re: What did you do to your Volvo today?