1999 S70 NA Evita P0340 long cranking [Loose connector] Topic is solved

Post by **abscate** » 20 Feb 2021, 05:41

Got the battery cable resolved, now getting a P0340 cam sensor error.

Car running ok, but cold starting is taking about 5 seconds of cranking. , vs the 1/2 second before.

I’ll sort out if it is sensor or wiring by troubleshooting today. Have spare for swap. I’m going to examine wiring carefully as I was fussing with the loom a lot while I was doing the battery cable.

I had a couple of idle stalls while I was doing the cable, so the sensor may have been going out then.

Post by **abscate** » 20 Feb 2021, 10:55

Well, one of the short ones.

Either I pulled it or the connector is no longer locking and shook free, but I found the cam sensor loose and disconnected.

Plugged in , cleared codes, and problem solved

Cranking time now 0.5 second as before

I’ll zip tie it when the wind comes under 25 mph

Post by **foggydogg** » 20 Feb 2021, 11:24

Our all-purpose excuse for when things didn't go as planned on the boat was "High winds and heavy seas."
Especially useful for electronic issues.

Post by **abscate** » 20 Feb 2021, 13:34

foggydogg wrote: ↑20 Feb 2021, 11:24 Our all-purpose excuse for when things didn't go as planned on the boat was "High winds and heavy seas."
Especially useful for electronic issues.

“Marines on board”