oil sump to block, anaerobic sealant, 2001 xc70

lrock · Post by **lrock** » 24 Dec 2025, 13:06

under the impression that the oil sump to block was sealed with the orange (i believe elring el-liq 74, correct if wrong) anaerobic sealant, however i see no appreciable sign of it, is this what one would expect it to look like after 25 years on the mated surfaces? these pictures are as yet untouched/cleaned surfaces.

: volvo_oil_sump012.jpg (61.87 KiB) Viewed 199 times

i have much higher resolution images if needed, just trying to be light on site/browser resources.
thanks

Post by **Blacklab467** » 24 Dec 2025, 13:18

That looks about right, mine looked the same. I used permatex upon reinstallation, can't recall the part number but anaerobic sealant.

Post by **abscate** » 24 Dec 2025, 14:03

That’s what it looks like correctly dosed. Most people use way too much

https://www.amazon.com/Permatex-51813-A ... r=8-1&th=1

lrock · Post by **lrock** » 24 Dec 2025, 15:08

i have the el-liq 74, is permatex preferred?
applied with foam roller, correct?

darylrobert · Post by **darylrobert** » 24 Dec 2025, 20:38

Yes, i used the Volvo stuff, only need a small bead. Used green scotchbright to clean surface and tiny foam roller for sealant. Make sure to clean out the oil pickup mesh.

XC70Rider · Post by **XC70Rider** » 25 Dec 2025, 00:11

With the sump dropped replace all the O-rings and gaskets with this kit

https://www.fcpeuro.com/products/volvo- ... r-30750783

I rolled on Permatex Anerobic Sralant 8 years ago with no issues.

lrock · Post by **lrock** » 25 Dec 2025, 00:54

XC70Rider wrote: ↑25 Dec 2025, 00:11 With the sump dropped replace all the O-rings and gaskets with this kit

https://www.fcpeuro.com/products/volvo- ... r-30750783

I rolled on Permatex Anerobic Sralant 8 years ago with no issues.

already ordered and received