Login Register

1995 850 Engine died while driving, slow cranking

Post Reply
Jaybar
Posts: 35
Joined: 27 Jul 2016, 18:19
Year and Model: 95,97 850
Location: Manchester,NH

Post by Jaybar »

Check voltage at Battery lowest should be 13.8 if lower Robert DIY can show the trick I learned by soldering red line on the battery it worked perfect.

User avatar
RickHaleParker
Posts: 7195
Joined: 25 May 2015, 14:30
Year and Model: See Signature below.
Location: Kansas
Has thanked: 8 times
Been thanked: 977 times

Post by RickHaleParker »

13.8V is a charging voltage from the alternator, if the battery is fully charged it will drop to 12.7 -12.8.
Open circuit ~12.73V = 100% SoC (State of Charge).
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )

Jaybar
Posts: 35
Joined: 27 Jul 2016, 18:19
Year and Model: 95,97 850
Location: Manchester,NH

Post by Jaybar »

Good to know when I had that problem voltage at battery was 11.7 and I opted with the soldering trick.

nautalter
Posts: 6
Joined: 30 Jul 2018, 01:24
Year and Model: 1995 850 & 1985 360
Location: Port Dickson

Post by nautalter »

Ok, new negative cable installed on Saturday, a slight improvement, New positive cable from terminal to starter lug on Sunday and it sounded better. The battery was on a charger over night but it never got started. It did fire up once or twice but that was it. New battery purchased yesterday, same one as before, now just over a year old. Installed this morning and not much of an improvement.
Back to the head scratching event.

dj_v70
Posts: 240
Joined: 19 Jul 2014, 13:51
Year and Model: v70 2003
Location: ri
Has thanked: 7 times
Been thanked: 23 times

Post by dj_v70 »

You should check voltage between cable at starter and ground at starter specifically while cranking. I suspect that you don’t have 12.6v.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post