They aren't too diffiicult, I'm not sure what the exact size receiver you need is but my ball joint press I got from sears had one that fit. Ill post the size if I get a chance to look at it again
found this on youtube
S80 T6 Control arm and ball joint replacement question
-
chrism
- Posts: 1309
- Joined: 28 January 2009
- Year and Model: S80 / 2005
- Location: Atlanta, GA
- Has thanked: 7 times
- Been thanked: 78 times
I was able to seat the ball joints by tapping them in with a hammer and drift. The end of the drift needs to be placed as close to the rubber boot as you can get it without damaging the boot. Move the drift to different spots around the boot as you tap it in so that it goes in straight.
-
- Similar Topics
- Replies
- Views
- Last post