Low beam calibration

007 · Post by **007** » 15 Oct 2012, 22:49

Hello, recently my low beam lights are looking down and I have to turn ON the fog lights always to have a good illumination...

I would like to know if there is a computer/electronic calibration that can be performed?, I tried with the ¨plastic white screw¨ that each headlamp has, but the problem is that when I turn the low beams ON, they turns ON and after 2 seconds (approx...) they go down, and only illuminate a few feet from the vehicle.

Thanks to all replies!

Post by **precopster** » 16 Oct 2012, 06:01

Is this for an XC90 and what year please? Your title and your post state neither.

Post by **jimmy57** » 16 Oct 2012, 07:57

Sounds like a Bi-xenon headlamp issue. No message in the DIM?

007 · Post by **007** » 16 Oct 2012, 09:27

precopster wrote:Is this for an XC90 and what year please? Your title and your post state neither.

Hi, thanks for the reply. This is a 2004 T6 XC90.

007 · Post by **007** » 16 Oct 2012, 09:29

jimmy57 wrote:Sounds like a Bi-xenon headlamp issue. No message in the DIM?

Thanks for your reply. No message. Which would be the error/failure message?