The problem with replacing the inner boot without disturbing the outer boot is that the 3 rollers are 'staked' in the cup. If you look at where they would exit the cup, there will likely be a point on the end of the cup that has been flattened to prevent the wheel exiting. You can either remove the ...

An engine….$200,000…. A great engine, but..

We're excited to introduce TWO new footwell cupholders: the 3rd-gen P80 cupholder (for 850s and S/V70s), and a new design for most P2 models (S60, V70, XC70, S80). Both fit discreetly in the passenger footwell, securely holding bottles up to 104 mm wide. Available in a variety of colors to match you...

Well I fixed the heater fan that wasn't running on 4th speed. Turns out it was a relay and not the resistor, shoulda looked at a wiring diagram before replacing the resistor... Well a cheap general switching relay fit the original relay exactly so I happened to have one of those at home and now the ...

That's the Supreme Court light - your time's up.


Here's a non-car funny I like.....

Here's a good thread viewtopic.php?p=333659#p333659

So I stumbled upon a '98 V70 GLT that is missing its head due to overheating. Head was removed years ago and is now MIA.. My questions are: Do the low pressure turbos and the high pressure turbos use the same head ? That is do they both have sodium filled exhaust valves. And if I'm replacing the he...

w/o trying to push you over to swedespeed, I think there should be valuable info over there, there are alot of people doing RN swaps, so they might know about the similarities and differences.

I’ve got a 99 head sitting up inAlbany with one stripped head bolt it can’t get it off the block.

I think it was a t5 block B5245T3 but that should work

I’ll see if I can get a plan to get it off

[email protected]

I can't speak for what he sells at the moment.