I replaced my fuel pump yesterday and used this tool to do it. Your design works. I field tested it for you. I printed in PETG 0.6mm nozzle at 0.32mm layers and 100% infill. Total print time was about 7 hours. 43 meters and 129g of Total material used at an estimated cost of $3.22 for this particula...

I won’t leave Volvo as long as this Forum is alive. There isn’t a better forum of knowledge, help, and polite behavior in existence. I’ve sent and received parts from other continents supporting my fleet; Oxford commas and semicolons are just another added perk.

We are moving to a new place. All my car tools are still in my old garage. Today I drove on a battery down there to replace a dead alternator. I had it rebuilt a few years back, but it started acting up a year ago and died completely a few weeks ago. Have no time to figure out what did I do wrong, d...

Step 1. Install a lift.

Is this a Toyota forum? Nothing else breaks in your 20+ y.o. Swedes, so you guys chat about batteries and such?

Bought flex pipe for exh downpipe. Correct fit? I watched what seemed like 3 orangex videos totalling about 3 hours regarding that job and learned nothing. i watched those same videos too, measured my pipe at 2 3/8th, so I bought 2 1/2 " , it doesn't matter if it doesn't slip fit as I'm weldin...

The groundhog didn't see his shadow today so you can start in 30 days.

a 3 lb hammer , long chisel and put the knuckle on concrete.
it will soon give up.

There are YouTube’s on this. After you remove the lock cylinder ( Dremel needed to notch two security torx for removal) Now you need to drill three holes in indexed spots for compression of the snap ring thst hold the lock cylinder in. Once that is out, you can remove all the lock tumblers and you a...

br0dy519 wrote: ↑07 Sep 2024, 13:13 Swapped and flipped my steering end stops to opposite sides in order to prolong life.

Maintainer level Greybeard.