mine just got worse this morning and the real muffler is dragging on the ground, check your rear muffler hanger,
i think that can damage the flex pipe.
Gonna have to fix mine sooner than i wanted, just turned the heater on in the garage.
drat.

don't start it until you resolve the cam contradiction. if you can rotate by hand its fine. look at the cam lock tool, the locking notches are different, one sit high, the other sits lower. the cam lock tool should have the intake higher than the exh. its possible you're 180 out of sync. the noise i...

If you have vida you can generate an invoice, charge yourself $800 then go out and spend it on tools.

Follow my blog for more get rich tips.

new rack using old lines ...
a mechanic told me if he changes the rack he also changes the lines to prevent customer come backs.

this one goes a bit deeper.

mtd240 wrote: ↑25 Feb 2024, 15:05 I used Toyota FIPG to patch a slit in one of my 07 XC70’s CV axle boots. 70k miles later, still fully sealed

Now that I’ve posted here, it will surely fail tomorrow.

and it color matches too !

I And how do I get Vida Monitor? vida monitor shows up at the bottom of your screen in the taskbar. it will be red, then turn yellow, you have to wait until it turns green, its quite small and hard to see . my laptop is slow, it takes a few minutes until i get the green light. once you get the gree...

gas smell around the wheel well is usually the fuel pump cover plate, they are known to crack, mine did. if you smell gas on the driver side step around and smell the passenger rear wheel well. if you're not convinced, wrap that gas hose with paper tissue , then masking tape and drive it around unti...

they should make the rear hardware out of the same material because the front nuts didn't corrode at all. The 3 nuts come off with no problem. I used this hardware kit, https://www.fcpeuro.com/Volvo-parts/V70/?year=2004&m=1280&e=2105&t=5&b=6&d=586&v=97&keywords=8642449KT ...