Login Register

Search found 436 matches

Return

by jonesg
19 Mar 2025, 02:27
Jump to forum
Jump to topic

Re: P0016 power train code, camshaft sensor wires?

vida will give a more definitive code than that.
On mine it said "cam signal out of range", no kiddin, the cam sensor was loose, it couldn't get a steady signal.
by jonesg
19 Mar 2025, 11:37
Jump to forum
Jump to topic

Re: P0016 power train code, camshaft sensor wires?

Hopefully you can find the issue, but it doesn't do any harm to check the timing belt is timed correctly. When I had the head of I reset the timing per the standard instruction. VVT hubs were pulled off the camshafts in the process, so I guess that could be the issue. Is there a sensor or diagnosti...
by jonesg
20 Mar 2025, 10:12
Jump to forum
Jump to topic

Re: Possible Haldex Failure 2003 XC70

Its usually the angle gearbox that grinds the coupler sleeve. Unplug the haldex to stop the pump (or pull the fuse near the rear hatch),see if the noise goes away. Or drop the prop shaft to uncouple the rear end physically. Or remove the independent drive shafts at the rear wheels and unplug the hal...
by jonesg
20 Mar 2025, 16:49
Jump to forum
Jump to topic

Re: Fuel filter: WIX 33603 vs 33605

It looks like there are two Wix fuel filters that come up for the 2004 xc70. One is 6.5" long, the other 8.25 inches. Both look to have the same ringed/barbed fuel line connections. Is there a reason to choose one over the other? Do they both fit? I would ask the tech guys at FCP, I'm fairly s...
by jonesg
20 Mar 2025, 17:16
Jump to forum
Jump to topic

Re: Possible Haldex Failure 2003 XC70

CEM-1A64 is no communication with the haldex, mine has that because I pulled the fuse to disable the AWD, it doesn't affect anything else. CEM-1A61 might be coming from the haldex problem. CEM-1A5F, bad communication with ABS, this can cause the trans problem too, it can be as simple as a bad ABS wh...
by jonesg
23 Mar 2025, 18:55
Jump to forum
Jump to topic

Re: Weird Fuel Pump leak from top of housing?

beewstew wrote: 23 Mar 2025, 11:17 This is the $10 fix for now. Won't know that it works until tomorrow...

PXL_20250323_171042567.jpg
thats the ticket.
Don't turn the ignition on to check for leaks or it will set an SRS code.
Make sure all the seatbelt sensors are connected before ignition on.
by jonesg
27 Mar 2025, 10:21
Jump to forum
Jump to topic

Re: Aluminum wheel corrosion welded (?) to hub

Loosen wheel bolts, raise the car, slip a wheel chock inder the tire from the side, lower the car, done.
Especially effective when the car doesn't run.
by jonesg
28 Mar 2025, 16:18
Jump to forum
Jump to topic

Re: Possible Haldex Failure 2003 XC70

I've been up to aviemore skiing in yrs past, it gets just as snowy here in northern maine, just saying you should be fine with fwd.
by jonesg
29 Mar 2025, 20:38
Jump to forum
Jump to topic

Re: Possible Haldex Failure 2003 XC70

Fascinating thing, I heard a lot about torque steer before driving for a while w/o my shaft, but I didn't find it to be really much of an issue. Don't know how this suggests my car might be broken. :-D Or maybe I'm not just sporty enough in my driving. I thought it was fine. same here, I don't drag...