20220614_062306.jpg the crank pulley is keyed to the crank, it can only go on in the correct position. If the crank shaft moves, mine did, reinstall pulley and move it back until the pulley lines up relative to the timing mark on the block. Its a non issue. A bit of white touch up paint to make it ...

I think I'll try it too, my car only came with one key. https://www.aliexpress.com/item/2251832842093891.html?spm=a2g0o.productlist.0.0.7272657dzkliPO&algo_pvid=a98db8a8-ae77-46ae-be57-b68b86d1e02f&algo_exp_id=a98db8a8-ae77-46ae-be57-b68b86d1e02f-35&pdp_ext_f=%7B%22sku_id%22%3A%226732566...

Hi Everyone! Recently, my son's 2004 XC70 started exhibiting a weak battery. When I put a multimeter on the battery leads with the engine running, it was showing less than 12 volts. Last week, we replaced the voltage regulator with a new Bosch unit because the old brushes were a bit worn down. The ...

so I finally sealed the leak at the cat to resonator flange. The flange bolt holes were rotted away. , I put a split coupler on each side of the joint, a 3 inch section of 63mm pipe inserted (hammered) in the cat side, resonator side is slightly bigger , the flange bolts drew it together. . Resized_...

br0dy519 wrote: ↑16 Jul 2022, 17:22 Isn’t BOAT an acronym for “Bust Out Another Thousand”?

boaters learn to scale down,
aluminum hulls outlive glass and are lighter, cheaper to maintain and need less power.
Old car, old boat, old snowmobile, buy em cheap and fix em up.

I installed a new cartridge in mine, comes all balanced, from the UK, $185 on ebay. But oil leak is usually just the gasket at the top of the drain tube. Swap out the seal at the bottom end of the drain too. $7 fix. On mine the shaft was snapped in half. Its much easier to just swap out the cartridg...

posting for a local guy in Maine. $500 plus freight.

I like to trace circuits with a fox and hound type tracer, it injects an audio signal you can track with a detector probe.. It can track a wire through a fender. Disconnect car battery doh. The version I bought was around $29 on amazon. https://www.amazon.com/Tracer-Circuit-Tester-Alligator-PTE/dp/B...

Sorry, follow-up question. Does anyone know the size(s) needed of flare wrenches for my P2? Metric I will assume. 13mm worked for me. these cost me around $12, excellent. https://www.amazon.com/SATA-Full-Polish-Removing-Replacing-Conditioning/dp/B07V4315PX/ref=sr_1_2?crid=1E41OLGT8U5WS&keywords...