You will feel it if it’s out of place. The plastic cap won’t screw in nicely by hand.

Todays forecast, light rain with a 99% chance of….

Ban hammer!

454cid….$50 repair

Kat $500 repair, sorry

My wrote up on key cylinder replacement is here, on Evita the 1999

Ignition key tumbler problem
viewtopic.php?f=1&t=98078

viewtopic.php?f=1&t=98078

Interesting, that first part number if you check it on FCP is not for a white block. Only listed for a red block. The ones I pulled were both from P80's, but both were NA motors. One was from a 97 850 NA the other from a 98 S70 NA. A noticeable difference to the part number you list as the 1389618 i...

Wrong forum, I know, but I miss you guys, yes specifically P80. I spent six weeks providing 24/7 care for a family member, then got a month at home where I wrestled some necessary repairs on the rusty 2000 V70 Geronimo which my girlfriend is relying on. Now I'm back providing care again, likely for ...

Hey Everyone, It's been a bit, but I finally got the oil cooler hoses installed and a picture taken. It's working out great! I wanted to thank everyone for your help here in helping map out a solution. I ended up going with some silicon heater core hoses from DO88 in Sweden https://www.do88performan...

Following this thread because we have been pondering a few custom setups for phone mounts...

Both door marker lights in my V70 I were broken (well, one was missing entirely), so I bought two new used ones (very inexpensively) which are not broken.. However today I found out that they are in fact broken as well, the clip is broken off on one and cracked on the other one... PXL_20240407_14561...

Had to run a few errands today and the sun was shining so took the 850 for it's first proper drive of the year Apr16a.jpeg Once home I decided to sort out my show mats and put the obligatory stripes on them Apr16b.jpeg Finished off by giving the original 28 year old mat a wash (no dressing on this a...

I did this installation on my '97 a few years ago and spliced into the front turn signals, just as you're suggesting above. Has been working well with no issues, and can recommend this approach. Good luck!