I know about the resistors are in the cem but I do tests on the table. I test CEM L, I have 2 pieces and the reading does not start, I guess I did something wrong with the teensy program? See ..... Some of the CEM-L will not read on the bench unless you comment out this line in the code. #define CE...

My CEM-L goes into some sort of standby mode after like 20 ms if it sees no DIM on the bus, maybe other modules, too. I usually run the cracker without autodetect and power up the CEM when the cracker says "Putting all ECUs into programming mode.".

charlie13 wrote: ↑20 Apr 2022, 09:48 I want to connect to table P3. The can contacts are in the blue plug. I am looking for power and minus. Will anyone help? May be priv

This is what I had.

charlie13 wrote: ↑22 Apr 2022, 13:06 No

Oh, pardon, change p1 to count from 20.

Source found here.
7f 27 35 (Invalid key.)

charlie13 wrote: ↑06 May 2022, 09:56

vtl wrote: ↑06 May 2022, 09:31

Thank you for help.
K line with dice.
Did I connect something wrong? Will someone suggest?

This is correct:

That seems to be your own Frankenstein version of the cracker speaking - a mix of P3 branch and some real old master? You are the developer, you are in charge now

Makes sense: November 2021 when p3 support branched off.

Someone needs to merge all the pieces together... Sirloin's p1, p3 and manage not breaking p2 I'm trying to be pretending that someone is not me.