This might help. June

SOLVED!!! In order to have properly working SRS warning light and no SRS 127 code stored in SRS system,you just need to add a wire from ignition switch(x-supply,yellow violet wire)to connector "B" on pin B5. B5 is spare in '96 & '97 850. That's all. IMG_20191222_211344_539.jpg IMG_2019...

Take a look at this thread viewtopic.php?t=37781

Lots of 850 speaker info with replacement product model numbers...

Personally, they annoy me a little because they don't seem to fully return to their horizontal resting spot very well, and I don't find them all that useful. You might find the results of this poll interesting. I deleted mine. https://www.matthewsvolvosite.com/forums/viewtopic.php?f=1&t=49983 S...

I replaced my oil drain plug with a tap. Hoping for less messy oil changes in the future 👍 Time for first oil change after drain tap installation. I must say it went pretty well. I was planning on attaching a hose/tube to the tap and lead it right to my oil recycle tank but I couldn’t find any at h...

Thanks Nikolaech. I have no idea how to do the EEPROM check you are talking about but thanks anyway. That SC-901 I'm looking for parts for the CD-changer flap, is now in the 'R' until I can face removing it again and retry the now cleaned SC-900 laser and rubber drive rollers that were not as clean ...

Incredible! I might finally get a full s80 phone system installed. For the unique factor of course, not the functionality. Thank you for the post!

I've had a couple of these expansion tank caps for the coolant system crack over the years. The most recent one cracked last month when I overheated the car a little bit due to a disconnected fan relay wire. This is a Gates cap purchased from FCP 3 or 4 years ago. I cut the cap open to see what's in...

50/50 anti freeze mix coolant has a boiling point of 223*F. A 15 pound cap pushes that number to 268, which I think is plenty hot. If any of my two-decade old cars gets any warmer than that I would rather they puke on the ground to let me know they are feeling poorly, as opposed to pressurizing the ...

I was asked to post pictures of an SC-900 motherboard for comparison to an Japanese version of the unit. So here we are: PXL_20230520_222925718.jpg Above is most of the main board PXL_20230520_222940217.jpg Above the the lower RH corner of the board as seen in the 1st picture PXL_20230520_222947890....