I'm sure I'm not the first to do this but I couldn't find anything while searching. One of my FOB stopped working a few years ago and getting a replacement was too cost prohibitive. I previously tried repairing it but was unsuccessful. This should work for both the earlier FOB without key and new kn...

I love it! The radio reception seems to be weak, but other then that it's been great. I use the hot spot on my phone to provide wifi for the head unit. Google maps right there on the center console. Full featured with all the features: add stop, speed traps warning, search, etc. I can send map links...

This is the second s60 I had where the position light warning would go off and on. The first, I fixed by replacing the light bracket with a replacement from the junk yard. Then my T5 started experiencing this problem, so I feel it's probably a common issue. The solution was to bend the ground tabs o...

My '05 S60 center console creaks a lot. I removed it this weekend to fix the issue with the shiftier not stay in drive, i.e. falling into manual mode. I tighten all the torx screws inside the center console, there are about 12, about 1/4 to 3/4 of a turn. This is old plastic so don't go crazy. After...

I got tired of the 12v cigarette charger falling out so I installed a USB dual port charger. I looked into installing under the HVAC controller, but there is not much room there. I also think having the cable coming from the rear is less messy up front and in the rare case I have someone in the back...

IMG_20230206_225943323.jpg I posted this picture of USB ports I added under the rear 12v charger a few days ago In the "What did you do today'" thread. I choose this placement because it keeps the wire out of the way and had a near by 12v source. But you could be place it anywhere. You ne...

Pull the transmission dip stick and smell the fluid. It's hard to find but there is a yellow dip stick. Control Arm Bushings: grab wheel at the 3 and 9 o'clock position and wiggle Shock Mount Tear: With the hood open push down on the car and ensure the shock mount isn't torn. Do this on both sides

@crasbe thank you for posting and sharing your 3d model. Will be using this when I replace my subframe bushing in a couple weeks.