Thank you polskamafia mjl, erikv11 and Lee!! My visit to the salvage yard confirmed the location of the connections (for the ground wire, wiring harness clamp, and knock sensor clip) as well. On my volvo, the knock sensor clip is attached to the black plastic covering (has an accordion look to it) t...
Greetings all! Once again, I am attempting to better understand my Volvo! It has been sitting for the winter and have put it back on the road - the problem is the codes! I am still getting 505 and either a 130 or 131. When I put this on the road after reassembling the cylinder head etc. a few years ...
The third picture above shows the new clip on the left, old clip on right, with the end of the shaft. Itโs not entirely clear but the newer clip has a slightly smaller gap between the two ends.
Success ๐๐๐ Still a little hard to put into park, but was able to backup the car out of the driveway and move the green V70 out. Still need to have some welding done on the exhaust and find the cause of the hard steering on the green V70, then have the car inspected! I will look for that cable, wise...
Indeed, the wrong tie rod was installed (I was sent two passenger sides when I ordered these back in 2021). Makes sense to check the contents of the boxes when they arrive!
Have ordered two new tie rods!
Thanks to all for your help in solving this mystery!!