Handled by local mechanic with impact wrench.

Subsequest issue was 17 years of rust welding defeating Kroil and my recently-acquired impact.

I thought about heat, but only have a propane plumbing torch. Buddy says that’s knife to gunfight territory. Going to the pros Friday.

Figured it out

Cruise control vacuum pump

Mounting to/under battery tray through a slot and secures with a screw (missing)

What a great community!
Old car info, humor, interesting opinions, and grammar lessons!
No wonder I visit at least once a day. (Also, I have little else to do.)
volvolugnut

Sorry for the holy massive threadbump but I just solved this exact problem on a customers 04 XC90. I figured I'd share it for anyone else in the future searching the net for a solution.

Check fuse 38 INSIDE the car on the drivers fuse panel. Mine was blown. Lights are working again!

Depends on your engine management system: Fenix 5.2 and Motronic 4.3 connect pin 2 on immobolizer to pin 5 on ECM plus pin 4 of IMMO to 36 on the ECM in the case of Motronic 4.3; Motronic 4.4 and MSA 15.7 connects pin 4 of IMMO to 36 of ECM. I would think the ECM controls everything not the IMMO. Ed...

Received a mirror from bmdubya1198, promptly shipped, well packed and as described.

You can download VDASH from D5T5 free - https://d5t5.com/ They also sell cables that work with VDASH. But be aware - it’s a “pay as you go” model You can buy or download VIDA 2014D (the older ‘offline’ version from various places. The official VIDA is free to download from Volvo but it has steep sub...

This is an old topic that seem afflicted with misinformation - in part due to the evolution of knowledge and technology of retrofitting LED bulbs in reflector housing that were designed for halogen bulbs. The fact is - regarding such conversions - what was true a few years ago is incorrect today. Pl...

turns out my fuel filter was toast. I bought a new one but then compromised the fuel filter connector o-rings pulling them off. (I replied on another older thread so forgive me if I'm repeating here.). I should say, they were basically rusted on there. Nothing was getting them off without prying. Th...

Wrapping this topic up So my hose was short and cracked at the end. I cut back to good hose. Then I cut off a couple inches to attach to the canister and I spliced in a hard or plastic tube as an extension. So far so good. Also learned about the valve at the end of this hose and researching on here ...