Search found 98 matches
- 09 Nov 2021, 09:52
- Jump to forum
- Jump to topic
Re: Yet another misfire thread - Cylinder 3 - No compression
... So, I've been driving with my coil pack harness disconnected... this perhaps means my injector is still spraying fluid, huh? I did it like this because when I removed the injector harness, the OBD reader gave me a very weird code insinuating I lost power to cylinder 2 as well. Couple this with ...
- 12 Nov 2021, 08:39
- Jump to forum
- Jump to topic
Re: Massive Oil Leak
Finally finished and put everything back. Been busy with other things. Here are the work I did. - Front crank seals, intake and exhaust side - Water pump - Timing belt, serpentine belt - Timing belt tensioner - PVC breather and oil trap - Pulled down the oil pan and cleaned - All o-rings in the are...
- 19 Jan 2022, 16:57
- Jump to forum
- Jump to topic
Re: 2006 S60 2.5T FWD - PCV system advice
This is the full kit: https://www.fcpeuro.com/products/volvo-pcv-breather-system-kit-s60-turbo-s60turbopcvkit This is the partial kit without the complex coolant pipe: https://www.fcpeuro.com/products/volvo-pcv-breather-system-kit-s60-v70-xc70-s80-xc90-genuine-volvo-kit-504286 Thanks, Neil. If you ...
- 05 Mar 2022, 10:15
- Jump to forum
- Jump to topic
Re: Aw55-50 sn valve body "B" with solenoids slots up!
Hello, I have an AW55-50sn in my car, year is 2001, valve body is "B" but the solenoids are up. I couldn't find this configuration in documentation in MVS. My question can I replace my valve body with any model? Or should I replace it by early model? Thank you. IMG_20220301_103029.jpg Acc...
- 06 Mar 2022, 09:10
- Jump to forum
- Jump to topic
Re: Aw55-50 sn valve body "B" with solenoids slots up!
Thank you very much for the quick and long reply, Now its clear for me. I'm planning to replace the valve body with later version And I hope to fix my gearbox which symptoms are: 1-Gearbox fall in limp mode just after starting the engine when (cold) and very harsh revers 2- gearbox dont fall in lim...
- 09 Mar 2022, 11:29
- Jump to forum
- Jump to topic
Re: Coil Wiring Cleanup
Hello friends, I'm picking up the pieces from a failed ignition wiring harness repair. The tech ordered the splice kit and made some clean looking connections. I'm getting 12V on each coil connector, so far so good. He only labelled 2 of the connectors however, so I don't know which coil 3 of the c...
- 04 Apr 2022, 16:17
- Jump to forum
- Jump to topic
Re: Aw55-50 sn valve body "B" with solenoids slots up!
Hello guys Today I've replaced the Slu, Slt and Sls Solenoids using Rostra kit ordered from the US. The Ss1 was changed too. Now the car doesn't go to limp mode bust still have harsh shifts up and down, very bad slam when engaging R. 2-3 Flare too. When the car is hot I have something like 2 second...
- 16 May 2022, 09:26
- Jump to forum
- Jump to topic
Re: The "ARD fuel injector filter removing tool"
I have seen several mentions of this tool, but no photos, and no idea if a generic tool like this one: ASIN: B07PDJ83JB on Amazon. (for some reason the board does not like the link, so pasted as text with a space after the slashes below): https:// amazon.com/Injector-Basket-Removal-Optional-Filters...
- 12 Jun 2022, 08:48
- Jump to forum
- Jump to topic
Re: PCV service turns into oil pan work.
Noticed an oil puddle near the pass/front wheel on our 06 2.5T v70 with 170k. Once I lifted the car and looked, most of the wet area seemed to be at the front crank seal although there's oil on the belt and both cam pullies also (pulled off the top of timing belt cover too), may be leaking from the...
- 12 Jun 2022, 09:00
- Jump to forum
- Jump to topic
Re: 2001 v70 T (p80 ETM problem ) Is this the ETM issue that I've read so much about on this board?
Not cheap but a recent (20 2021) Volvo rebuild.
https://www.ebay.com/itm/181840976917?f ... SwT~Zin9QO
https://www.ebay.com/itm/181840976917?f ... SwT~Zin9QO






