for what its worth, this is my airbox repair .. Not the best photo but the filter is nicely sealed, That tab stops the lid from lifting up but does nothing to stop the the box from pushing out, i just pushed it back and drilled a small hole and fitted a long bolt or self tapping screw. I etched a &q...

I purchased a Volvo switch for $3usd about 3 months ago from a seller in the states. Switch arrived in a padded envelope but was undamaged have since noticed the same item re-listed again. Its possible seller has another switch and is using same photo to save time but reading sellers feedback it app...

it looks like the high pressure headlight washer, sell it on ebay as near new

How to get a factory ECC switch to operate aftermarket accessories, using a modified switch connected to a LM 393 voltage comparator module. Basically the module detects a change in voltage as set by the user.

ive added a TPMS on/off switch for my aftermarket setup. I had contacted some businesses that laser etch (same method used on OEM switches) and most said no but one said they could try, was too expensive so i had some vinyl stickers printed. looks better than that generic switch.

To change your ECC from F to C is easy, just unclip the face plate. To remove and clean sticky buttons properly (i used chemicals),first remove electronics PCB,it comes out with the temp sensor (needs a good pull). Then press the buttons with a large screwdriver from the back. Do not try and do this...

My car has one fan -> me. but as they say "two is better than one"

you can add rear sensors from car years upto 2004 i believe without connecting canbus, its just +pos and -neg connections, if you want factory factory then the dealer i think it is.

I received my USB ports today and they fit the Volvo 12v lighter very nicely. I have yet to properly test the operation but data and power works, no speed tests done yet. These sit flush not like the genuine USB adapter, however they do not supply power, they are Female USB to Female USB and anodize...

check the wiring, i had a bad connector once,very difficult to solve. Does it fail while going over bumps in the road? check all connections while engine is running.