Voltage is ONLY present between Pins 1 & 5 within 8 secs of turning on ignition to Pos II on a functional throttle. It's safe to say that if you hear the throttle operating, the voltage to the flap is there. The other circuit (between pins 2 & 4) requires power for the potentiometer. As I me...

Golf2 "With the TPS disconnected, I could see 7v on pin 2 (ETM side)"

Which is the ETM side for you? The 5 pin side or the 3 pin side?

You should be fine to go ahead and install the Sacer TPS.

Output leads for throttle angle to the connector are yellow/green and red/blue. Once the Sacer is fitted power it up and measure the voltages at those leads. If you rotate the flap by hand they should vary.

When installed the sensor output on both sides should be between 1.35 and 1.45V.

Good luck

The 2002 model has no PEM. That was a later inclusion.

Dice is run from a program called Vida which runs on Windows operating system. Where Henry or Sergey is concerned they only need the Dice to be connected to the laptop's USB port and the other end of the Dice plugged into your OBDII port. They can use Team Viewer to remote in, provide any drivers ne...

Wheel bearing noise combined with ABS/Tracs message is usually a shot bearing. They wobble so much that the ABS sensor can't read the ABS ring on the CV shaft.

I'm up for a party!!

Try this thread: https://www.matthewsvolvosite.com/forums/viewtopic.php?f=40&t=83834 Which version of Vida are you trying to install? BTW you don't need to install Vida to have Sergey read the car/fix the car. You only need Dice USB drivers installed. Though I might add if it were me I'd be curi...

Hey NP. Glad it worked out!!

One of the guys on MVS pointed me to Dice/Vida selling at Walmart for $71 https://www.walmart.com/ip/New-2014D-VOLVO-VIDA-DICE-OBD2-Check-Engine-Code-Reader-Scan-Tool-for-Volvo-Vehicle-1999-2015-3/677685864 What's the world coming to?? You would need to send the ECM out with the TCM so they can be p...