Volvo Forum

No on the MAF, especially a RA MAF. It will spit codes if it isn’t metering right

Pull a couple of plugs and look at the gap. If it’s over 030 they are worn out and you may have a funky misfiring plug at load. New set of Coppers, under $25

Wow! The 1970s called and wants their circuit board back!

It sounds like release bearing noise based on the occurrence pattern

Pinged him on email. He was always a fantastic contributor here.

‘ Failed for sticker on D window obstructing view to the offside”

Or

“ Lack of dirt constitutes distraction hazard to other motorists”

Absolutely Bonny!

The hard fuel line slides right into that bell shaped connector and seals on those O-rings

It’s right above your index finger holding the ECT connector

THat is the ECT connector for the 99 00 years

Do those clamp to the fore-aft rails, or are they designed to take M6 screws into holes on the car ?

Love that label - inspired me to make up a

1999 V70 T5 M56 417 1/6

Two M6 bolts slide into that pipe where the yellow arrows point..,

Tough to access.

He’s fine. Busy stages of life.

I measured 326 mm but wasily had 2 mm of error in my measurement, with wheel on

I do confirm the two pot, two piston calipers

Search found more than 3366 matches

Re: Studder/hesitation when accelerating...new MAF?

Re: Dolby Pro-Logic; only central loudspeaker working

Re: M56 noise V70 1998

Re: RickHaleParker

Re: What did you do to your Volvo today?

Re: A $100 '99 V70 GLT

Re: Install instructions for Volvo "load bar" roof rack

Re: A $100 '99 V70 GLT

Re: RickHaleParker

Re: 2013 xc90 Platinum 7 seater brake options and parts