You be safe out there , and the MVS family has your back.

Our prayers and thoughts are with you and Jeff, drive safe! Take 5 mph off that speed for me!

You need to replace the front fender if the hinges bent

I did mine in a snow bank,

wizechatmgr wrote: ↑12 May 2019, 00:45 Was it possible the last time they did the rear crank seal? That's a real pain in the backside to get at typically.

Also called the crank seal, and that one does require at least a transmission pull, if not an engine pull.

I forgot you are really low miles on this cars. Don’t worry about a spare coil until 100k miles.

Remembered this from doing the 1999-on PCV You put the banjo on the fitting, with the two copper washers, then you put a sacrificial orings on the bolt to hold it together. Once you get the banjo started, snip the oring and pull it off. You can also snag the oring with a pick and pull it off until i...

Check your PVC for pressure, if your catch that before it gets pressure, you save a lot of money.

Are you a DIY chap/ gal? Many here have picked a wrench for the first time with guidance both online and sometimes just meeting new people

If you put a ziptie loop on the top of the belt , to get it onto the PS pulley, you get your fingers out of the way and can work it onto the pulley easier. Clip and remove at end, or use a pick to release it and resell it as tested zip tie, Not getting the ribs into the grooves as noted above is the...

In a 1997, up near the grab handles on each side of the car near your ears

In 1998-1999 , it transitioned to a dash position , next to the heated third rear seat button to right of steering wheel,

Mike, I think Manov has driven down to you...