Here is a progress pix for front passenger. The only way, I found, is to tilt and flip it over on to the back seat, and then maneuver it out of the rear door. MVS_Seat_0130.jpg MVS_Seat_0131.jpg MVS_Seat_0132.jpg MVS_Seat_0133.jpg MVS_Seat_0134.jpg MVS_Seat_0135.jpg MVS_Seat_0136.jpg MVS_Seat_0140.j...

Agreed with the above. I swapped my original Volvo slide pins into the rebuilt calipers I bought a few years ago, and they were still looking good when I installed new brake pads last weekend. The slide pins that came with the rebuilt caliper were strongly attracted by a magnet (indicating that thos...

I was doing an axle CV boot today so I decided to check the front caliper slide pins at the same time and re-grease the front pads. This car (98 V70) already had rebuilt calipers when I got the car (213k miles) and they are still on there (279k miles). Fortunately I kept the badly rusted, factory ca...

The problem was leaking vacuum hose between Manifold and pressure switch on top off Radiator.

David

my 2010 XC60 T6 went down this road a couple of weeks back. I wasn't driving it but electrical system service needed meg, misfire, stepped into to make it go, lost even more power, then quit running and coasted to side of road and would not do anything, not even hazard flashers. I collected spouse a...

Well I figured I will let everyone know what happened so that if anyone comes onto the forum they may get an idea. So I ended up sending my personally rebuilt throttle body in XemodeX and they sent me a fully rebuilt Throttle body (FYI do this and dont buy the Sacer. Less headache and the whole thin...

Does it change when cornering? That would point to a wheel bearing starting to fail. If that's the case, it'll get worse until the noise is very pronounced when cornering and much less going straight.
As for the tires, to remove any doubt, you could change wheels if you have a second set.

Ran out to Harry's U-Pull-It in Allentown, Pa. with my bro before it got hot. Pulled a ruby red metallic passenger front door from an '05 XC 70. Came home and replaced the door on my '04 XC 70 (we parked in the shade). For XC 70 owners -- my front passenger door was rusting out along the bottom lip ...

Forgive me if this is an ignorant comment but shouldnt the voltage regulator brushes be the same length? If they contact on the shaft then that would allow it to collect the difference off the coils to ground and then filter it through a bridge rectifier and vreg to get your output car voltage. If o...

Also the bolts are torque to yield one time use only. So new bolts must be installed. June