You might want to swap out the large light bulbs while you are in there. I used a drill with about 1/4 inch thick of masking tape wrapped around a wooden pencil. It took me at least 1 hour to go 30K miles. The rubber eraser doesn't work as the rubber crumbles and mucks up the gears. The drill runs i...

I would place the MAF in serious consideration. A disconnected MAF is supposed to idle, and not be able to get around the block. If this were a turbo, I would have said that one of the intercooler hoses was loose or broken. For non-turbo, check the air filter box to throttle body tube very carefully...

You could try cleaning the PnP contacts by 'rowing' the shifter from R to D about 20 times. Check the condition of the ATF, if it is not red, then a flush is in order. Or, just replace the PnP. The 'incorrect gear ratio' is bogus. BTW, when the up shift arrow is on and you are driving, shift to L wh...

You will want to remove the air intake tube between the air cleaner and turbo so that you can clean out the PCT orifice. During the reassembly, do not tighten the bottom bolt of the intake support bracket until the intake manifold is back in place. The bracket needs to move slightly to center the to...

Nothing special, get replacement screws at a hardware store - something that won't rust.