One serpentine belt drive water pump, A/C, PS and Alternator. If it fails, it can wrap around the cam drive belt and destroy valves.
volvolugnut

I had a set of tires with the indented appearance many years ago. I drove them without failure until they had minimum tread.
volvolugnut

I found Detroit Axle has rebuilt axles for your car with great prices and lifetime warranty. I can't vouch for the quality, but the brand has been mentioned here at MVS before. Web site: https://www.detroitaxle.com/shop/cv-axles/front-driver-side-cv-axle-shaft-for-93-97-volvo-850-1998-s70-v70-exclud...

Hey Smackdab I have been living with that light for years. I changed my front sensors didn't work so I figured it's the back ugh. Don't think I can get that wire through the gas tank with Vaseline even .lol well going to the junkyard this weekend .i gotta I gotta I gotta. ❤thanks To get over the 'c...

I believe this engine will have a cold start injector and cold start relay to provide extra fuel when it is cold. The cold start relay may be bad or the temperature sensor for the cold start system may be bad. Do you have a service manual for this B21F K-jet? Also, if this car sat idle for many mont...

It seems a set is priced at less than the individual pricing for 3 or 4 wrenches. If you expect to have other vehicles in your fleet in the future you will need other sizes. They can also be used for nuts or bolts that are in danger of rounding off, but you don't have a closed end wrench of 6 points...

Just use the Dollar store commas....they are just fine. And if you are short some ellipsis for spacing, cut the tails off the commas.

volvolugnuty

They are likely filled with dirt. Try a spray of your favorite cleaner to flush out the dirt. I can't remember if they are pinch type or slide side ways. If pinch type get needle nose pliers. If slide type, get an open end wrench of proper size to give you some force on the small tabs.
volvolugnut

I have no photos and have not changed on all wheel drive, BUT I can provide encouragement. I changed the HP hose on 2001 V70 and it is a struggle, but can be done. I started from the top front of the engine and worked it down and back.
volvolugnut

If a heater hose is leaking, it is tempting to tighten down hard on the hose clamp. However, better long term results are likely if you drain some coolant below the hose level, remove the hose, clean the likely corrosion on the hose barb, cut off the end of the hose were it was clamped (assuming hos...