Are damper mounts the struts shocks not sure Will the Haynes manual clearify? A Strut is a damper. You only have two on the car, they are on the front. Front Damper mount = Strut Mount. The rubber/metal part that binds the top of the Strut to the body. When the rubber rips loose. The top of the Str...

1. Disconnect the Engine coolant temperature (ECT) sensor.
2. Place a 150 -170 Ω resistor across the wiring harness.
3. Start engine see if the fan is running.

184 Ω = 100 °C (212°F).
170 - 150 Ω corresponds with a temperatures greater then 100 °C (212°F) .

I Understand what the error code means so I will have to do the same I guess. Just about anything that messes with the Air/Fuel ratio can trip P0420. Possible source Misfiring Leakage in the intake system Leakage in the exhaust system Faulty fuel pressure Uneven compression Damaged catalytic conver...

jbade wrote: ↑19 Nov 2019, 13:03 RickHaleParker,
3.2 V6 (2011)

3.2 SI6 (Short Inline 6 cylinder)

Simple DIY Rust converter.
1 liter distilled water
20 gm Tannic acid
15 gm Phosphoric acid
Let it work all the way through then seal with a protective coating.

You can get the acids on eBay ....

You could get it going again for $160.00 but at that price it not going to happen tomorrow. You will need to send them the immobilizer module they will make the key and program the immobilizer. Then send it back to you ready to go. You might be able to find a local independent locksmith that can cu...

There is no 2007 S70 ...

This is for a 2007 S60.

Clean the MAF connector and test for Air leaks in the intake system. P0101 Possible source Air leakage in the intake system Contact resistance or oxidation in the mass air flow (MAF) connectors Damaged mass air flow (MAF) sensor. Blocked intake system P0102 Possible source Air leakage in the intake ...

Engine runs normal but weak, puffs of smoke and low compression are the symptoms of worn or stuck piston rings. One could confirm this by placing a table spoon of oil in the cylinder (Wet Compression test). If the oil cause the compression to rise the rings are not sealing. You could pull all the pl...

prefuse07 wrote: ↑24 Nov 2019, 19:54 I received this error:

Something went wrong in the install. Reinstalling over the existing install has always fixed it for me. Until you get this fixed, everything else is spinning your wheels.