I need to see what I can do about my PS pump. The top bolt threads are stripped out, so I can only use 2/3 bolts. I’ll probably get a thread insert. Dip the bolt in molten wax, you want just a thin layer of wax on the bolt. Pack the bolt with JB Weld. Insert bolt, clean off excess and let JB Weld c...

That's an idea, I might have to give that a try. More tips on working with JB Weld. 1. Use the Original JB Weld not the quick set. 2. As stated above JB Weld will not bond to Wax, Oil, Grease or dirt. Bonding surface needs to be clean, squeaky clean. 3. If you need the JB Weld to spread thinner or ...

PowerMatz wrote: ↑09 Jun 2021, 10:43 Hi, here is a new part number:

You are misinterpreting the output. The software found 30786579 in the database. 30786579 is a known CEM.
If a CEM part number is not found in the database the software will output " "Unknown CEM part number XXXXXXXX. Don't know what to do".

patcal wrote: ↑09 Jun 2021, 18:18 ECC lights are not blinking at me.

Not winking at you anymore .. it lost interest in you.

patcal wrote: ↑09 Jun 2021, 15:58 It was the ECC control panel.

Did you try cleaning the ECC connectors before you replaced the ECC?
Sometimes just resetting a electrical connector will exterminate the Gremlins.

im not sure this was asked before but are P3 CEMS supported in the future, i did try 2 of them but i get unknown CEM and script stops P1, P2 CEM-L and P2 CEM-H are supported. P2 CEM-B and P3 are not supported. The side attack used on the P1, P2 CEM-L and P2 CEM-H does not work on the P2 CEM-B. P3 i...

Clean for debris around the blower fan. I could of been something locking up the blower fan.

The 2.9L six cylinder is a long head. The longer the head the more prone it is to warpage. That one of the reasons they invented the V8. Two short 4 cylinder heads are less prone to warpage.

Compression test and do the chemical test for exhaust gases in the coolant.

thefisch wrote: ↑15 Jun 2021, 07:47 It wasn't leaking at all prior to this trip and was pressure tested a month ago. Oh well - back luck I suppose.

It had your attention, liked it and wanted more.

Or lose some of the forward overhang!! :lol: :lol: Cut Sugar out of the diet and eat more fats. Sugar consumption is the cause of forward overhang not fats consumption. The body uses fats as energy efficiently. Sugar get converted to fat and stored. This is why so many people are always tired. Ener...