I’m not sure on this one.

If you plan on the drill out method, that would take care of it, though.

Be careful with that tool, if the links are really frozen, it will break the tool.

I plan to use heat together with the tool. My second question after reading about this operation: You need to undo the lower shock absorber mounting, right? Don't bother with the heat. It has never worked for me. Attacking it with a drill across the top is usually enough to get it to break free. (I...

You can jack one side of the car and do one side at a time. Both rear wheels don't need to be off the ground to replace a delta link. I guess was never answered. :P To avoid fighting the the rear sway bar, you might loosen/disconnect it on the PS side of the car, but other than that, one side at a ...

I've melted them out with a plumbing torch a couple times now (combined with some judicious drilling and use of the proper delta link removal tool). The secret is to heat the trailing arm around the delta link and not put the heat directly on the rubber -- unless you like flaming gobs of goo droppin...

Unless you have a breach in the system where you can see oil leaked out, you do not want to add any oil when topping up. Recharge with straight R134a.

2 terminal switch? PSI reading is with ac off or on? Disconnect cable from switch and put your jumper on cable harness. Read ohms across switch with ac off. Read ohms across switch with ac running. If you have a pressure gauge, also record pressure on low side port with ac both off again while on. R...

The cup should have a protrusion on it which goes into a hole in the spring seat. If that’s gone it will migrate.


Probably not available new anymore.


…and it is available ! 3546435 part number

If I were in this situation, I would check to see if the ECC unit has stored any error codes and make a note of them if so. Then I would clear the error codes and see which codes are repeated. I'm guessing you've already checked the cabin filter is clean (or removed) so it can't block airflow. Anoth...

Following on from what jreed says, are you getting no air at any of the outlets or just not the vents to the windshield. I am trying to think why you would not get any air out of any of the outlets at all, as normally even if the cold air flap is not working if you set to cabin recycled air you shou...

Our '97 US-spec GLT has an emblem.