This has been a journey, so I condensed it into the bullet points below. I really appreciate any insight from the community members who know more about these cars than I do.

- Bought ’06 XC70. Lifted a bunch, put it on 32” wheels and tires from a Jeep Rubicon. Wheeled it for months and had a great ...

I swapped the front seats (and engine, M66, brakes, etc) from an '05 S60R into my '06 XC70, and I keep getting the code "SRS-DD10 Communication Control Module. Faulty Communication". Even when I clear the codes on VDASH, this one reappears immediately without even turning the car on.
I have checked ...

You will need to actively clear the SRS code, it won’t self correct. VIDA or dealer


Thanks for the reply, but I am a bit confused by the wording here. Are you saying without the sensor plugged in I will constantly have the code and will have to clear it using VIDA or a dealer?
OR
If I install an ...

I did a full S60R swap on my XC70, including the front seats. I noticed that the S60R passenger seat did not have a loose connector to plug into the connector from the floor. I checked the OEM seat from the XC70, and it had a sensor in it. The code SRS-DD10 shows up on VIDA (SRS-DD10 communication ...

Got the car running with MT software thanks to Mat Leavesley (legend). The car ran fine before the swap, and I've obviously taken my sweet time getting it going. (This has led to a few smaller issues where I unplugged/unscrewed something and forgot about it later) The car has been turning over fine ...

Fixed the issue. I had the wires crossed somehow. Immobilizer message gone.

You’ve got Yagger right there in San Jose, too, as a resource.


Sorry, I don't spend a ton of time on the forums. It looks like Yagger is someone who works at Total Auto Tech?
https://www.datatransferring.com/
Is that correct?

I am leaning towards pulling the CEM and bench testing it, as Mat ...

Backstory: I bought a 2006 XC70 and a 2005 S60R. The driveline in the XC70 was working fine. I took the engine, trans (M66), and some other parts out of the S60R and put them into the XC70. I am in the final stages of the swap, getting the software for a manual trans and the new engine flashed onto ...

Just downloaded this to avoid using a Virtual Machine. It says it only supports Windows 7
I don't know enough about computers to work around this, so Virtual Machine it is...

I figured it out while talking to a Volvo buddy, and it's a lot more simple than I imagined. I'll leave the post incase anyone comes across it in the future.

Note: I was asked to check the reverse lights on the car when the beeping was occurring. The reverse lights were on 100% of the time.

Both ...