Thanks for the help

That's the problem. The alternator is still in the car and I don't want to remove it till I have the replacement. The numbers I can read are on the black plastic cover on the back side. They are 0121 715009 and 6g9n-10300-ma. I suspect those are the numbers for the cover. FCP did a vin search and sa...

I am prepairing to do the alternator on my wifes 2008 xc90. I am having a hard time Identifying if it is a 180 amp or 150 amp. fcp Groton said it could be either one and they did not know what if any physical differences there are. The numbers on the back show up on the WEB as being both. Has anyone...

For awhile now my 2008 xc90 had what I thought was a drivetrain noise that was getting progressively worse. It only made the noise with the car in gear and would change with engine load and speed ( kind of sounded like brake rotors getting turned) Well it turned out to be a bad engine mount, the upp...

I just got the old harness out for the aft o2 sensor and you are correct.The harness for 15062 is much longer than 15063.I need 15063,thank you for the speedy and accurate response.

This could be filed under stupid question but here goes.I bought an O2 sensor on line.The bosch web page says for my car it needs (sensor 15063 to chassis nmb 342001) or (15062 from chassis nmb 342000).I have chassis number 443440.I ordered sensor 15062.I found sensor 15063 installed in my car.Thats...

Rear cam seals,see my most recent post.

I just had a misfire problem in my car and what I found was excessive moisture in the distributor cap.Upon further investigation I discovered that the rear cam seal behind the ignition rotor had come out of its seat.I suspect that crankcase vapors were the cause of the condensation and a slight oil ...

Thanks for the advice.When I removed the rotor I found the rear cam seal out of its seat.I replaced both rear cam seals,spark plugs,cap and rotor now all is fine.

This morning the car(1998 v70xc) died on the wife.Had it towed home got it in the garage and pulled up engine codes,misfire cylndr 1,misfire cylinder 2,multiple misfire.The car did start right up for me and ran fine but i did have misfire codes in the past with no noticeable performance problems.I'v...