Thanks all of you! lots of good info....
as technician , I sometimes have trouble finding time or wanting to find time to fix my own cars...the cobbler and his shoes...
I now have good direction to purchase the right stuff, thanks again guys!
MERRY CHRISTMAS and so forth and so on...

does anyone know where to purchase or obtain , VOL-FCR software?? A reliable, safe source? I see some trial / demo versions available on the internet but not sure who the the original software comes from. Does anyone have the info? Or info on good volvo diagnostic software for model years(S70, V70, ...

Hello , It has been a while since I have posted a question here. I own three Volvo's ,a 1995 850 GLT 2.4L, a 1998 S70 2.4L and a 1999 V70 2.4L. However, I always return to the best Volvo Forum there is MVS! Here is my issue: 1998 S70 2.4L; the dash board is lit up lick a Christmas tree! SRS light il...

It is!(a pressing repair) Very Much So. thank you you guys.
So far, I rewired the the complete drivers door. (which I found to be melted, etc) I went down to the bone yard a and pulled a the whole harness as far back as I could cut, I wanted the OE obviously so i could match wire etc.

I know I know, this issue has been visited many a times....however, my problem is different.... It all started way back, one hot summers day when all the power windows stop working. I tried to clean the master driver door switch to no avail. I tried to replace it, again with no success. I did find o...

Would I still have spark from the coil pack with a bad can sensor? Does any one know what happens when the can sensor fails? What else shuts down?

Hello again Volvo enthusiasts ! My wife's 95 850 glt N/A 20 valve cranks but wont start. so far i have determined that there is SPARK between the coil pack and primary ignition wire. I have also observed a fuel smell after cranking. There are no related codes from the OBD 2 connector with code reade...

I will try those suggestions saturday after work and get back with, ...hopefully, a successful story. Otherwise I may just leave old inboard cage in there and replace outboard side and shaft, repack with grease etc, etc...(I wish I thought of that the other night) afterall, it is only the outboard c...

I ve tried it all. Usually an axle shaft is a 30 minute job for me. i have tried with a crowbar and some specialty tools. (not any volvo special tools ) All I succeeded in doing was pulling half the axle out. the cage and shaft are still inside trans. This is a night mare ! I've heard the left side ...

fuel tank pressure sensor? ok, i'll look into that. Do you think an OEM wire schematic will identify the wire/connectors and their locations?